[off-topic] Cutting raised floor tiles

[Arie Hol]

On 14 Dec 2011 at 16:45, Russell Steicke wrote:

> Hello,
> 
> I have to get a single raised floor tile cut in half for cabling.
> This tile is 600mm square, particle board, laminated top, with a steel
> backing on the bottom.  Wood places have refused because of the steel
> back, and steel engineering places have refused because of the wood.
> I wouldn't want wood shavings in the steel workshop, either.
> 
> I can't be the first person to need this done.
> 

Have you considered asking a stone mason - they often use high pressure 
water jets to cut hard stones such as marble and granite to obtain highly 
accurate and clean cuts that need minimal polishing after the stone has 
been cut.

It may only cost you several phone calls to find out.


Regards Arie
---------------------------------------------------------
For the concert of life, no one has a program.
---------------------------------------------------------