[plug] Trying again

[Craig Dyke]

Not sure if i asked this question incorrectly or is it just too difficult to
answer.

Anyhow ... here i go again (please even reply if i have stated question
poorly or more info required:))

Am trying to set up xfree to use my radeon card.
After using XFree86 -configure and then adjusting file XF86Config (see
attached)
I ran startx and get told that agp is not available.

>From here i do a modprobe agpgart and get:

agpgart: Maximum main memory to use for agp memory: 439M
/lib/modules/2.4.18/kernel/drivers/char/agp/agpgart.o: init_module: No such
device
Hint: insmod errors can be caused by incorrect module parameters, including
invalid IO or IRQ parameters.
You may find more information in syslog or the output from dmesg
/lib/modules/2.4.18/kernel/drivers/char/agp/agpgart.o: insmod
/lib/modules/2.4.18/kernel/drivers/char/agp/agpgart.o failed
/lib/modules/2.4.18/kernel/drivers/char/agp/agpgart.o: insmod agpgart failed

And Xfree never seems to load my radeon card either. If i modprobe it that
seems to be fine but still get line in
Xfree log that says:

(EE) RADEON(0): [agp] AGP not available
(EE) RADEON(0): [drm] failed to remove DRM signal handler

Am running on an Athlon 1100, 512MB Ram, Radeon SDR.

Any help would be greatly appreciated :)
-------------- next part --------------
A non-text attachment was scrubbed...
Name: XF86CONF
Type: application/octet-stream
Size: 1818 bytes
Desc: not available
URL: <http://lists.plug.org.au/pipermail/plug/attachments/20020720/7fa6b2fd/attachment.obj>