[plug] NIC mismatch error

[Ben Jensz]

Ethtool, if you've got it installed.

"ethtool eth0" would give something like this:

Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: g
Current message level: 0x00000007 (7)
Link detected: yes


/ Ben


Shawn Owens wrote:

> How can I tell what duplex setting a particular NIC is utilizing; I’m 
> receiving a mismatch error on the firewall after adding another card 
> of the same type.
>
> Thanks.
>