[plug] change settings and what to do

[David]

simon wrote:
> David (davidatt at conceptual.net.au) wrote:
> 
> 
>>                              PPPoE
>>Username:
>>davidatt at conceptual.net.au
>>IP Address              N/A
>>Default Gateway         N/A
>>Primary DNS             N/A
>>Secondary DNS           N/A
>>System Uptime
>>Model                   NB5 ADSL2+
>>Serial Number           none
>>Firmware Version        62.51.1-004
>>Ethernet MAC address    00:30:0A:34:71:28
>>DSL MAC address           00:30:0A:34:71:2a
>>USB MAC address         00:30:0A:34:71:29
>>NAT                     Enabled
>>Firewall                Disabied
>>
>>LOCAL NETWORK
>>
>>LAN IP Address           192.168.1.1
>>DHCP                     Enabled
>>Ethernet                 Connected
>>USB                      Disconnected
>>
> 
> 
> Hi
> 
> Which ethernet device do you have the ADSL modem plugged into? eth1?
> 
> Try
> 
> pppoe -I eth1 -A
> 
> and see if an access concentrator responds.
> 
> Also make sure that whatever eth device you are using for the modem doesnt
> have an IP address assigned to it.
> 
> --
> =================
> Simon Scott
> simon at chrome64.org
> mob: 0409113359
> =================
> 
> 
> 
> _______________________________________________
> PLUG discussion list: plug at plug.org.au
> http://www.plug.org.au/mailman/listinfo/plug
> Committee e-mail: committee at plug.linux.org.au
> 
HI

the ADSL modem i have got is a NetComm.. i have got it connected in to 
the computer. the neckwork card.....

ok i will do that

regards
david